Tips And Tricks For Curtain Track Installation
We don’t mean to toot our own horn, however we’ve been doing this curtain track thing for a while now, and we’re pretty good at it. Over the years we have now learned many lessons about the best ways to put in curtain tracks. Lots of our prospects are staunch do-it-yourselfers, which we applaud. Permit us to avoid wasting you some trial and error by sharing among the most useful tips and tricks we’ve collected.
GETTING STARTED
Virtually any curtain track set up project may be accomplished with a drill, miter or hack saw, screw driver, tape measure, and level. When you’ve obtained these available, the next step is to recollect some ideas which might be helpful for any project: ask for help; and measure twice, cut once.
SEEING IS BETTER THAN VISUALIZING
Before you cut a track or drill a gap – lay everything out on the floor in entrance of you. Take note of the relative positions of the curtain track, drapery hardware, and curtain panels. Consider how the curtains will stack, where they are going to hit the top of the track, the general size of the curtain panels, and the area between panel and floor. Adjust as wanted through hook position or tape height.
KEEP YOUR DISTANCE
We don’t care what you utilize to measure the distance from the ceiling to your wall-mounted bracket – as long as you employ the identical thing for each bracket. So seize your level, ruler, block of wood, whatever – just use it consistently. Do the identical for keeping a consistent distance from the wall and your ceiling-mounted track.
GLIDE IN FIRST
Trust us on this one – when using hooks on your curtains, put your carriers or glides onto the curtain track earlier than the track is positioned on the ceiling or wall. Should you’ve received a snap tape system, snap the carriers onto the curtain and then slide the carriers into the track.
SPLICE AND DICE
When splicing two tracks together, use the factory-reduce sides for splicing, moderately than the hand cut. We’re certain you’re a good hand with your miter noticed, but the factory reduce end is bound to be sq. and can facilitate a greater joint.
In the event you loved this information and you wish to receive more details concerning ceiling track for curtains assure visit the page.
GETTING STARTED
Virtually any curtain track set up project may be accomplished with a drill, miter or hack saw, screw driver, tape measure, and level. When you’ve obtained these available, the next step is to recollect some ideas which might be helpful for any project: ask for help; and measure twice, cut once.
SEEING IS BETTER THAN VISUALIZING
Before you cut a track or drill a gap – lay everything out on the floor in entrance of you. Take note of the relative positions of the curtain track, drapery hardware, and curtain panels. Consider how the curtains will stack, where they are going to hit the top of the track, the general size of the curtain panels, and the area between panel and floor. Adjust as wanted through hook position or tape height.
KEEP YOUR DISTANCE
We don’t care what you utilize to measure the distance from the ceiling to your wall-mounted bracket – as long as you employ the identical thing for each bracket. So seize your level, ruler, block of wood, whatever – just use it consistently. Do the identical for keeping a consistent distance from the wall and your ceiling-mounted track.
GLIDE IN FIRST
Trust us on this one – when using hooks on your curtains, put your carriers or glides onto the curtain track earlier than the track is positioned on the ceiling or wall. Should you’ve received a snap tape system, snap the carriers onto the curtain and then slide the carriers into the track.
SPLICE AND DICE
When splicing two tracks together, use the factory-reduce sides for splicing, moderately than the hand cut. We’re certain you’re a good hand with your miter noticed, but the factory reduce end is bound to be sq. and can facilitate a greater joint.
In the event you loved this information and you wish to receive more details concerning ceiling track for curtains assure visit the page.
